OMC Bulletin No. 2276 Rev. 1 - Cooling System Modification

April 1994 revised OMC bulletin for cooling-system modification on specified 60, 65 and 70 HP outboards.

OMC Outboard Service Bulletin
Powerhead
No. 2276 Rev. 1
April, 1994
Subject:
Cooling System Modification
Models:
1986 (CD) thru 1994 (ER) 70 HP
1987 (CU) thru 1994 (ER) 65 HP
1989 (CE) thru 1994 (ER) 60 HP
Problem:
An engine can be damaged by overheating when air becomes trapped in the upper half of the cooling system. This can happen when:
  • the engine is idling with a blocked or restricted thermostat bypass hole
  • the engine operates in aerated water, such as a pontoon boat wake
Solution:

Relocating the water pump indicator outlet tee to the top of the cylinder block ensures air can be vented from the cooling system and an adequate water level in the cooling system can be maintained at idle.

1 Remove the indicator hose from the tee and discard hose. Remove tee from exhaust manifold cover. Seal the original hole with plug P/N 321164. Apply OMC Gel-Seal II to threads of the plug.

2 Measure 2 in. (51 mm) Ⓐ forward from the rear corner of the exhaust manifold cover. Measure in from the exhaust cover gasket 1⅜ in. (34 mm) Ⓑ. Mark the intersection with a center punch.

Note Grease the tips of both the drill and tap to prevent aluminum chips from entering the cooling system.

2 To prevent damage to the water jacket, mark an 11/32 in. (letter “R”) drill bit so that the drill will not penetrate more than ½ in. (12.7 mm). Drill a hole through the casting and tap threads to ⅛ in. NPT. Apply OMC Gel-Seal II to the threads of the original tee and install in hole so the water pump indicator nipple is facing the rear.

3 Cut a piece of hose 19 in. (48 cm) long from a roll of 3/16 in. (4.76 mm) I.D. hose, P/N 913435. Install the new hose.

Factory illustration 1Factory illustration 2Factory illustration 3
CR94-2

Related marine products

eBay: OMC / Evinrude part 321164

Listings matching the part number

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.

Related products

Cooling-system hose and fittings - recommendations coming soon.