OMC Service Bulletin No. 2277: Ignition Failure

February 1994 bulletin covering loose ignition pilot-ring fasteners on 1993 ET 20 through 30 HP models.

OMC Outboard Service Bulletin
Ignition System

No. 2277
February, 1994

Subject:
Ignition Failure
Models:
1993 (ET) 20 thru 30
Problem:
1For part of the 1993 model year the ignition pilot ring Ⓐ was held in place with nuts Ⓑ and studs. The nuts can loosen, causing ignition failure.
Solution:

1When servicing ignition components located under the flywheel on these models, check to see if the pilot ring is held in place with nuts Ⓑ and studs.

2If nuts and studs are found, replace them with spacer washers and screws Ⓒ, from Washer and Screw Kit, P/N 436926. Follow the installation instructions in the kit.

Figure 1 pilot ring nuts and studsFigure 2 replacement screws

Related marine products

eBay: OMC / Evinrude part 436926

Listings matching the part number

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.