OMC Service Bulletin No. 2281: Jack Plates

OMC discusses jack plate mounting support, stern bracket safety, and the need for a one-piece mounting surface.

OMC Outboard Service Bulletin
Midsection
No. 2281
August, 1994
Subject:
Jack Plates
Models:
All
Problem:
1 Jack plates or set-back plates with two-piece mounting surfaces do not provide support for the motor’s stern brackets. This lack of support can twist the motor’s stern brackets, wear tilt tube bushings, and bend or break components. Damage caused by the use of this style of jack plate will not be covered by warranty.
Solution:
2 Use a jack plate with a one-piece mounting surface to completely support the stern brackets.

Note A jack plate must provide tilting clearance and be strong enough to support the motor should it strike an underwater object at high speed.

⚠ Failure to mount the motor on a flat and rigid surface can result in sudden loss of steering and shifting control.

Use of a jack plate to raise the motor will usually result in an increase in boat speed. As the motor is raised there is an increase in steering torque and the boat may become unstable. Anyone operating a boat with a jack plate must have sufficient driving skill and drive carefully.

Figure 1: Two-piece mounting surfaceFigure 2: One-piece mounting surface

⚠ Safety Related

CR94-27

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Power Trim

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.