OMC Service Bulletin No. 2284 - Screws, Upper Mount to Steering Arm

Published in August 1994, this OMC bulletin addresses screws, upper mount to steering arm for 60° 150 and 175, 1991 & Newer.

OMC Outboard Service Bulletin
Midsection
No. 2284
August, 1994
Subject:

Screws, Upper Mount to Steering Arm

Models:

60° 150 and 175, 1991 & Newer

Problem:

The screws in the upper motor mounts can release their initial torque, which can cause fretting between the upper mount and the steering arm. Fretting in this area can lead to excessive engine vibration.

Note Excessive vibration can further loosen and damage the upper mount screws, steering components, and critical engine mounting components.

Solution:

Whenever you service 60° 150 and 175 engines, check the upper mount screws for type and amount of torque. Inspect for and replace any damaged parts.

Early engines used hex head screws with separate flat washers. Discard all early screws and flat washers. Replace them with the newer washer-head screws, P/N 340497. Do not use any grade of thread locking compound.

When you tighten the replacement screws, or check the torque on newer screws, follow the two-step torquing procedure outlined below.

1)   Torque the upper mount screws to 100 ft. lbs. (136 N·m).

2)   Wait 20 minutes and retorque the upper mount screws to 100 ft. lbs. (136 N·m). Do not reverse the screws when retorquing them.

Note These new screw and torque recommendations apply to all 60° V6 engines, 1991 and newer. Mark Page 5-3 in each of your 60° LV service manuals to show the new installation and torque procedures.

Related marine products

eBay: OMC / Evinrude part 340497

Listings matching the part number

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.