OMC Service Bulletin No. 2293 - Reverse Lock Components

April 1995 OMC bulletin on reverse lock component inspection for 1995 9.9 and 15 HP four-stroke outboards.

OMC Outboard Service Bulletin
Midsection
No. 2293
April, 1995
Subject:
Reverse Lock Components
Models:
1995 (EO) 4-Stroke 9.9 & 15
Problem:

A small number of 1995 (EO) 4-stroke 9.9, 9.9 high thrust, and 15 models might have been assembled with incorrect reverse lock components.

If a 9.9 high thrust model was assembled with conventional reverse lock components Ⓐ, increased propeller thrust in REVERSE gear will not be available. This could lead to a loss of boat control while maneuvering or docking.

If a 9.9 or 15 model was assembled with high thrust components, the engine would lose its impact protection. Loss of impact protection could result in extensive damage if the engine hits an underwater object while operating in FORWARD gear.

Solution:

Inspect the midsection of any 1995 (EO) 4-stroke 9.9 or 15 model when the engine is in your dealership for routine service.

The high thrust reverse lock components are welded together and have a spring wire diameter of 0.090 in. (2,3 mm).

The conventional reverse lock components are two separate parts with a spring wire diameter of 0.072 in. (1,8 mm).

Refer to page 21 of your 1995 Final Edition Parts Catalog, P/N 437470, for detailed information about these components.

Original factory figure 1

Related marine products

eBay: OMC / Evinrude part 437470

Listings matching the part number

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.