OMC Service Bulletin No. 2296 - Propeller Installation

Published in July 1995, this gearcase bulletin describes checking propeller-to-trim-tab clearance on 50, 60, 65 and 70 HP outboards following the introduction of larger-diameter aluminum propellers. It identifies a replacement trim tab and describes clearance modifications.

OMC Outboard Service Bulletin header
Gearcase
No. 2296
July, 1995
Subject:Propeller Installation
Models:50/60/65/70
Problem:
1 OMC has released a new series of aluminum propellers with a larger diameter and improved blade design. These propellers have shown an increase in performance. When these propellers are used on 3-cylinder gearcases, the propeller blade tips might contact the trim tab plate.
Solution:
Verify for clearance between the propeller and trim tab plate. If the propeller contacts the trim tab plate, choose one of the following methods of repair:

2 Replace the original trim tab with P/N 127466 available from OMC SystemMatched Parts and Accessories™. The part number of the new trim tab also appears in the appropriate final edition OMC parts catalogs.

Or you can install the propeller on the gearcase and slowly rotate it until a blade contacts the trim tab plate. Mark the point of contact on the trim tab plate, then remove it. Machine a slot Ⓐ deep and wide enough for clearance of all three blades.

3 Modification to the leading edge Ⓑ of the trim tab might also be required on some models.

Install the trim tab and verify clearance.

Factory figure 1: three-blade propellerFactory figure 2: trim tab slot AFactory figure 3: trim tab leading edge B
CR95-40

Related marine products

eBay: OMC / Evinrude part 127466

Listings matching the part number

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.

Related products

Compatible trim tab replacement - recommendations coming soon.