OMC Service Bulletin No. 2313 - Engine Overheat

Published in April 1997, this bulletin describes a thermostat modification for early-production 1997 (EU) 60° V4 and V6 outboards that may overheat during acceleration or full-throttle operation.

OMC Technical Service Outboard Bulletin
ROUTE TO:□ SERVICE MANAGER□ SERVICE WRITER□ TECHNICIAN 1□ TECHNICIAN 2□ TECHNICIAN 3□ FILE
Powerhead
No. 2313
April, 1997
Subject:
Engine Overheat
Models:
1997 (EU) 60° V4 & V6
Problem:
The thermostat design used in early production engines could, in certain circumstances, allow the engine to overheat during acceleration or full throttle operation.
Solution:
If your customer complains of an engine overheat, verify normal cooling system condition as detailed in your OMC Service Manual.

If the cooling system condition is normal and an overheat is still experienced, remove the thermostat assemblies.

11. The sleeve Ⓐ, gasket Ⓑ, thermostat Ⓒ, and spring Ⓓ represent an early production design. Discard these components.
22. Order two Thermostat Kits, P/N 435597, and install thermostat Ⓔ, thermostat spring Ⓕ, O-ring Ⓖ, and cover Ⓗ in each cylinder head. Follow Thermostat Servicing procedure in your 1996 (ED) OMC Service Manual, P/N 507127.
Figure 1: early thermostat components A through DFigure 2: replacement thermostat components E through H
CR97-23

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Water Pump Impeller Kit

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 435597

Search for original or compatible replacement part 435597

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.