OMC Service Bulletin No. 2317: Inconsistent Valve Lash

OMC bulletin on inconsistent valve lash in 1996 and 1997 4-stroke 9.9/15 HP outboards.

OMC Technical Service Outboard Bulletin
Powerhead

No. 2317
May, 1997

Subject:
Inconsistent Valve Lash
Models:
1996 (ED) and 1997 (EU) 4-Stroke 9.9/15 (305cc)
Problem:

A small percentage of valve seats were not installed to their finished dimension.

The combination of running time, engine temperature, and high RPM will move the valve seats to their finished dimension, causing valve lash adjustment to change.

Solution:

Engines in Service

Changes in valve lash adjustment can cause hard starting or dying at idle.

1 Adjust lash on all valves following the procedure in Section 4 of your OMC Service Manual. Verify correct idle mixture, engine temperature, and linkage adjustment.

Engines Being Delivered

Follow the New Engine Check List in Section 1 of your OMC Service Manual. Run the engine for 15 minutes at 1000 RPM, 10 minutes at 3500 RPM, and five minutes at full throttle.

1 Let the engine cool completely and adjust lash on all valves following the procedure in Section 4 of your OMC Service Manual.

Submit a warranty claim to the OMC Warranty Department using the following information:

  • Flat Rate Code: P210
  • Flat Rate Time: 1.1 Hours
  • Failing Part: 438034
Valve adjustment illustration, Figure 1

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Angled Feeler Gauge Set

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 438034

Search for original or compatible replacement part 438034

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.