OMC bulletin identifying steering connectors for FasTrak and conventional midsections, including kits 175125 and 173700.

⚠ Safety Warning: Installing the wrong steering connector could cause stiff steering and accelerated steering cable wear. Steering cable wear could cause the steering system to jam or fail.
Carefully check and match the steering connector to the midsection style in these cases and every time you install a steering system or change an engine.
The 1998 90/115 SPL® models are equipped with the FasTrak™ midsection.
1 A FasTrak™ midsection is used on most power trim equipped 3 thru 6 cylinder outboards since 1991. It can be visually identified by its six thrust pin locations and three threaded holes in its steering arm.
2 You must use Steering Connector Kit, P/N 175125, on all outboards with FasTrak™ midsections. This steering connector is identified by its highly polished finish, a round disk (A) around the pivot screw, and a slight bend (B) near the steering arm end.
3 A conventional midsection is used on all 3 thru 8 cylinder outboards before 1991 and on selected models after 1991. It can be identified by its five thrust pin locations and two threaded holes in its steering arm.
2 You must use Steering Connector Kit, P/N 173700, on all 3 thru 8 cylinder outboards with conventional midsections. This steering connector is identified by its dull finish and a hex disk (C) around the pivot screw.



Suggested products related to this service bulletin. Verify fit and suitability before ordering.
Search for original or compatible replacement part 175125
Click here to search on eBayAffiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.