OMC Service Bulletin No. 2323 - TC-W3 Outboard Lubricant

December 1997 OMC shop information on plastic container distortion during storage of TC-W3 two-cycle lubricant.

OMC Technical Service Outboard Bulletin
ROUTE TO:   □ SERVICE MANAGER   □ SERVICE WRITER   □ TECHNICIAN 1   □ TECHNICIAN 2   □ TECHNICIAN 3   □ FILE
Shop Information
No. 2323
December, 1997
Subject:
TC-W3® Outboard Lubricant
Models:
All 2-Cycle
Problem:

Distortion of Plastic Containers

Ever since specially formulated 2-cycle lubricants were packaged in plastic containers, a slight pulling in of the sides of the containers has been noted after extended storage. The distortion is due to reduced pressure inside the container and is particularly apparent after the lubricant has been stored more than a year in a warm environment.

One of the characteristics of plastic containers is that plastic has a minute degree of permeability, which allows the passage of some elements, such as hydrogen, through sealed containers. With sufficient time and temperature, hydrogen will migrate out of the container. Air molecules cannot pass back in because they are larger.

An ingredient in all brands of TC-W3 lubricant is a solvent that improves low temperature flow (pour point) and miscibility with gasoline. Over time hydrogen in the solvent reacts with the plastic. As hydrogen is lost, the volume of the contents is reduced slightly. The sides of the container are sucked in as a result.

None of the base-stock of the lubricant and none of the special additives package is lost. The lubricating qualities are unchanged.

Solution:

Rotate your stock. Lubricants, like many other products, should be rotated with “first inventory in, first inventory out.”

The date stamped on the side of the case is the month, day, and year of production, i.e. 07 16 98. The older stock should always be sold first.

If you are questioned by a customer about the appearance of the container, briefly explain that the quality of the oil is unchanged. If oil is mixed in a fuel tank, all that is required is to follow the Fuel/Oil Mixing Instructions in the OMC Operator’s Manual. If a VRO pump is used, no special procedure is required.

CR98-03

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

NMMA TC-W3 2-Stroke Marine Outboard Oil

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.