OMC Service Bulletin No. 2331 - Pinion Bearing Replacement

Pinion bearing retainer identification and replacement instructions for commercial V4 and V6 Offshore gearcases.

OMC Technical Service Outboard Bulletin
Gearcase
No. 2331
June, 1998
Subject:Pinion Bearing Replacement
Models:Commercial V4 and V6 Offshore

Problem: 1 2 Two types of pinion bearing retainers were used in 1998 (EC) models and in service gearcases. Early production outboards and service gearcases used a wire retaining ring above the pinion bearing. Later units used a bearing retainer screw.

Solution: Carefully check for a wire retaining ring above the pinion bearing as you disassemble a gearcase. If your gearcase does not have a wire retaining ring, follow these steps.

3 Remove the screws securing the water intake screens. Remove the starboard screen to access the pinion bearing retainer screw.

2 Remove retainer screw before removing pinion bearing. See the OMC Service Manual for the rest of the pinion bearing replacement procedures.

Note: You must remove the retainer screw before you remove the pinion bearing.

2 After installing a new pinion bearing, install a new seal on the retainer screw. Apply OMC Nut Lock to threads of the screw and tighten screw to 48-80 in. lbs. (5-9 N·m).

See 1998 (EC) OMC Parts Catalog - Final Edition for part numbers, and OMC Service Manual for pinion bearing replacement procedures.

Factory illustration 1Factory illustration 2Factory illustration 3

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Heavy-Duty Internal/External Snap Ring Pliers Set

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.