OMC Service Bulletin No. 2359: Software Jumper Harness

March 2000 OMC instructions for software jumper harness P/N 5000901 on EMM-equipped FFI outboards.

OMC Technical Service Outboard Bulletin
ROUTE TO: SERVICE MANAGERSERVICE WRITERTECHNICIAN 1TECHNICIAN 2TECHNICIAN 3FILE
Electrical SystemNo. 2359
March, 2000
Subject:
Software Jumper Harness
Model:
EMM Equipped FFI™ Models
Problem:
The original instruction sheet that was included with OMC Software Jumper Harness, P/N 5000901, had incomplete information. Because of this, a revised instruction sheet was developed and packaged with later harnesses. Please keep this bulletin as a reference if you received an early version instruction sheet.
Solution:
Follow this procedure completely and its designated sequence to avoid internal software damage.
  1. 1.) Hook up your laptop to the engine using your data link cable.
  2. 2.) Turn key switch ON.
  3. 3.) Install the “GO” disk in the “A” drive.
  4. 4.) Type in A:GO
  5. 5.) The program will now ask you to shut the key switch OFF and install the jumper harness tool.
  6. 6.) After installing the jumper harness tool, turn key switch ON.
  7. 7.) Press “ENTER” on your laptop to initiate download.
  8. 8.) Turn key switch OFF.
  9. 9.) Remove the jumper harness tool.

Related marine products

eBay: OMC / Evinrude part 5000901

Listings matching the part number

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.