OMC Technical Service Bulletin No. 2363, March 2000. Hard or No Starting. Models: 90/115 FFI 2000 (SS).

OMC Technical Service Bulletin
Electrical System

No. 2363
March, 2000

Subject: Hard or No Starting Models: 90/115 FFI™ 2000 (SS)

Problem: If the engine is hard starting or the customer com- plains of deterioration in starting ease, a likely sus- pect would be the EMM. The problem is caused by the close proximity of the Start Assist Circuit (SAC) wires to the EMM. During cranking, when the SAC is operational, a strong electric field can interfere with the operation of the microprocessor in the -- ]

-) EMM. DP0374

Check for continuity between the case of the EMM and pin No. 17 of the rear 24 pin connector (with the connector removed from the EMM). If continuity exists, the EMM contains the potential defect.

A Disconnect Battery Cables from Battery.

Solution: In order to correct this defect, follow the attached instructions for re-routing the ground and power wires of the SAC. An EMM bearing the serial num- 2 ber 10,000 or higher will not exhibit this failure.

[1] Remove the two stator connectors from the port side of the EMM by squeezing the locking tabs and pulling straight out.

[2] Remove the rear starboard EMM connector.

[2] Disconnect the 2-wire round connector @ that powers the main relay.

A Safety Related

CRO00-03

Factory illustration 1Factory illustration 2

[3] Remove the 12V red wire that is attached to the battery accessory terminal at the lower left corner of the Power Distribution Panel.

Completely remove the front and starboard EMM mounting screws.

Loosen the rear port EMM screw just enough to slide the EMM free and raise high enough to pull the rear wires out from under the EMM.

[4] Remove screw that secures the two black ground wires attached to the plate underneath the EMM. Reinstall bolt in plate.

Route the two black ground wires ® along the port fuel rails and attach the wires to the upper starter motor bracket ground screw ©.

Route the remaining leads around the STARBOARD side of the EMM.

Route the 12V red wire along the starboard fuel rails and attach to the 12 volt accessory terminal located on the lower left of the Power Distribution Panel where it was originally located.

Mount the EMM back onto the engine.

Push the two port stator connectors back into the EMM making sure you hear them snap into place.

Install the rear starboard connector to the EMM and tighten the connector screw.

[2] Reconnect the round two-wire connector @ for the main power relay.

Attach a few tie-straps to the wires to keep them from getting caught on anything.

Reconnect the battery.

Factory illustration 3Factory illustration 4Factory illustration 5Factory illustration 6Factory illustration 7