OMC Bulletin No. 2366 Rev. 1 - Forward Gear Shimming

October 2000 revised OMC bulletin correcting forward gear shimming instructions for 1998 and 1999 four-stroke 70 models.

OMC Technical Service Outboard Bulletin
Factory illustration of dial indicator on gearcase
Subject:
Forward Gear Shimming
Models:
1998 (EC), 1999 (EE), 2000 (SS) 4-Stroke 70
Problem:

The shimming information in the following OMC® Service Manuals have been revised:

2000 (SS) P/N 787062
1999 (EE) P/N 787023

Solution:

1. Correct step 2, pg. 10-20, to read as follows:

“2. Install water pump impeller housing plate, P/N 5030724. Attach a dial indicator to the driveshaft. Zero dial indicator pointer to the impeller housing plate. Indicator pointer must be perpendicular to the impeller housing plate.”

2. Correct step 3 to read as follows:

“3. Read backlash on dial indicator by slowly pushing down on driveshaft. Driveshaft backlash must be within 0.020-0.030 in. (0.5-0.7 mm.).”

Also, change the statement, “Always use one shim only” to “Use as few shims as possible”.

Note The amount of backlash may be incorrect if measured without installing the prop shaft and OMC Gear Holder, P/N 342689.

Related marine products

eBay: OMC / Evinrude part 787062

Listings matching the part number

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.