ROUTE TO: □ SERVICE MANAGER □ SERVICE WRITER □ TECHNICIAN 1 □ TECHNICIAN 2 □ TECHNICIAN 3 □ FILE
⚠ Safety Warning
Subject:Dura-Tank Pick-Up AssembliesProblem:It has been determined that a limited number of 3 and 6 gallon accessory Dura-Tank™ fuel tanks, P/N’s 175981 and 175984, along with fuel pick-up manifolds P/N’s 176468 and 176469, were manufactured between 12/1/99 to 5/1/00 with an improperly formulated O-ring. This may cause the fuel tank to leak fuel when under pressure.
Solution:You will need to inspect your inventory. You will also need to contact any customers that may have purchased one of these affected tanks or fuel pick-up manifolds. For your convenience, we are enclosing an example letter that may be copied and used for this purpose.
To determine if you have inventory in stock that is subject to this bulletin, you should inspect each Dura-Tank™ by date code on the side of the tank. Listed below are the two date codes that are affected by this problem.
1If you have any Dura-Tanks with a date code of “0” in the year location or both a “12” and “9” in the year and month locations they must be inspected as described.

If you have any Dura-Tanks with affected date code, you should manually check the fuel pick-up manifold to determine those that need to be replaced or those that have been inspected and approved. Please use the information below to help in identifying parts.
2Fuel pick-up manifolds that have already been inspected and approved at the factory, will have a white dot painted near the fuel inlet. If the fuel pick-up manifold does not have a white dot, you must determine if the O-ring is proper (blue) or must be replaced (orange).
Safety glasses required. Before performing inspection, relieve the pressure in the tank by loosening gas cap. To inspect for the correct O-ring, depress the two yellow tabs while looking down the fuel inlet hole. If the O-ring is blue, the component is acceptable. If the O-ring is orange, the component is non-serviceable and will require replacement of the entire fuel pick-up manifold.
All correct Dura-Tanks sold as an OMC® Genuine Parts Accessory will have a white dot on the fuel pick-up manifold and also have a green “X” stamped near the bar code label on the shipping carton.

If a new fuel pick-up manifold is required, order from your OMC Genuine Parts Distributor and submit a completed warranty claim form. Please return the improper o-ring along with the two rear caps from the fuel pick-up manifold in a plastic bag with the warranty claim. Warranty claims received without the old parts will be returned.
Safety glasses required. Before disassembly of fuel pick-up manifold, relieve pressure in the tank by loosening gas cap. Remove the fuel pick-up manifold from the gas tank and push in on the two yellow tabs and hold for a couple of seconds. It is now safe to place an 1/8” drift pin into the fuel inlet and gently tap with a soft hammer. The rear two caps should now release. Remove the two springs and then the check valve and O-ring assembly.
If you have any questions please do not hesitate to contact the OMC Technical Service Department at 1-800-888-4662.
Failing Part Number: 9999937
Group Code: A
Flat Rate Code: FM01
Flat Rate Time: 0.5
EXAMPLE
Date
Customer Name
Address
City, State Zip
Dear Customer
Our records show that you have recently purchased a 3 or 6 gallon portable Dura-Tank™ fuel tank from us.
There is a possibility that this tank contains a defective fuel pick-up manifold. Please return your tank to us for inspection, repair or replacement free of charge as soon as possible.
There is a possibility that the tank could leak fuel if it is pressurized. This could result in property damage or personal injury.
We apologize for any inconvenience this may cause, but we want to ensure your satisfaction and safety.
Very truly yours,
Dealer Name