OMC Service Bulletin No. 2380: Cooling Hose Rerouting

This September 2000 bulletin provides a revised cooling-hose routing procedure for 1998-1999 70 HP four-stroke engines.

OMC Technical Service Bulletin
Powerhead
No. 2380
September, 2000
Subject:
Cooling Hose Rerouting
Models:
1998 (EC) and 1999 (EE) 70 4-Stroke
Problem:
It is possible for water to remain in the water jackets of the cooling system of these models when the engine is shut off and tilted up immediately. In colder climates, residual water in the cooling system can freeze and expand, warping the water jacket covers on the crankcase. Cooling water can then leak from gaps between warped water jacket covers and the crankcase. Rerouting of the cooling hoses will ensure cooling water will completely drain from the system when the motor is stopped.
Solution:

1) Remove the engine cover and port lower cover.

2) Remove the 3-way connector that connects the hoses to the water jackets on the crankcase, intake manifold, and vapor separator. Do not disconnect the other 3-way connector.

Factory illustration 1

3) At the intake manifold water jacket:

  1. Remove the 15 3/4 in., (400 mm), water inlet hose ① and cut it to reduce its length to 12 5/8 in., (320 mm).
  2. Remove the 3 1/2 in., (90 mm), water outlet hose ② and cut it to reduce its length to 2 3/8 in., (60 mm).
  3. Remove the 9 5/8 in., (250 mm), vapor separator hose ③ and cut it to reduce its length to 7 7/8 in., (200 mm).
  4. Install the 2 3/8 in., (60 mm), former water outlet hose, ② onto the water inlet joint pipe.
  5. Install the 7 7/8 in., (200 mm), former vapor separator hose, ③ onto the water outlet joint pipe.

4) Install the removed 3-way connector into the open end of the 2 3/8 in., (60 mm), hose ② as shown in figure 1.

5) Install the 12 5/8 in., (320 mm), hose ① onto the opposite end of the 3-way connector.

6) Install the water hose ④ from the lower crankcase water jacket to the open joint of the 3-way connector.

Check to make sure the hose routing matches modified figure 1 and figure 2.

7) Reinstall the port lower cover and engine cover.

CAUTION: After rerouting the coolant water hoses, operate the engine in water to confirm there are no water leaks at any of the hose connecting points. Do not overbend (kink), or twist the hoses during installation. When installing hose clips, position the tabs of the clip to avoid contact with other parts.

Factory illustration 2

Note: Service Bulletins do not constitute a recall. OMC will cover labor and material only if the engine is under warranty. You can submit warranty using OMNI or a standard Warranty Allowance Request.