September 14, 1959
Bulletin No. SB-736
Subject: Display stand - test tank, storage rack, and work bench Clamp kit-
75 H.P. Series engine.
A new concept in mounting the 75 H.P. engine to
the boat transom has been developed eliminating
the clamp screw arrangement. The small light
brackets bolted directly to the transom insure
a much safer, more rugged and cleaner installation.
The small clamp brackets, supplied with each
engine remain on the boat transom permanently.
The new 75 H.P. series engine requires a special
stand for display. This special stand is
necessitated by the newly designed method of
engine mounting. Also, a special clamp kit is
required on your test tank storage racks and
bench boards.
NOTE: In the very near future a drill jig will be
available to pre-set drill the boat transom for
engine mounting. This same jig will be used for
drilling the clamp mounting holes on your test
tank, storage racks and work bench boards. At
the time of availability of this jig, you will be
advised by bulletin.
The items required to complete one display stand
assembly for the 75 H.P. engine are as follows:
1 - 378090 Head
1 - 378091 Clamp kit
1 - 377484 legs set (short)
or 377485 legs set (long).
Items required for storage rack, work bench, and
test tank.
1 - 378091 clamp kit required for each place a
engine is to be supported.
Use the enclosed order form for requesting the items
required. Mail the completed order form to
Johnson Motors.
JOHNSON MOTORS
Jack Penland
Jack Penland
Service Department
JP:eb
NOTE: Post on Miscellaneous index.