March 2, 1960
Bulletin No. SB-765
(Supplement to No. SB-736)
Subject: CLAMP KIT, PART #378091 - 75 H.P. SERIES ENGINES.
Referring to Service Bulletin No. SB-736 dated September 14, 1959, we advised you of
the availability of clamp kit #378091 and its requirement for mounting the 75 H.P.
series engines on display stands, test tanks, storage racks and work bench boards.
We also informed you, paragraph 3 under "NOTE", that transom drill fixture assembly,
part #378253, would be used to drill the holes for installing the clamp kit. This
information is, however, erroneous and must now be disregarded in favor of the
dimension chart contained in this bulletin.
In preparing for the drilling operation, first mark a center line on the piece of
equipment intended to accept a 75 H.P. engine, i.e., bench board, test tank, etc.
This center line and top edge of the engine support then become the bases for all
the measurements shown in the dimension chart. Study this chart and make all clamp
kit installations accordingly.
Use to mount 75 H.P. series engines on display stands,
test tanks, storage racks and work bench boards.
JOHNSON MOTORS
W. W. DeWees
W. W. DeWees, Service Department
WWD:eb