Back to 1970s OMC service bulletins

Evinrude Bulletin #1004 - Tank Testing 1973 50-135 HP Motors

Issued February 1973, this factory safety bulletin explains how to keep an outboard in gear during tank testing using a stabilizer spring, P/N 304283. It warns of dangerous overspeed and exposed moving engine components.

1973 Evinrude first in outboards letterhead 1973 Evinrude Service Bulletin banner
MISCELLANEOUS #1004
February, 1973
TANK TESTING 1973 50 - 135 HP MOTORS
When tank testing the subject motors, it is imperative that the shift lever on the motor be held in the in-gear position by either physical or mechanical means.
⚠
SAFETY WARNING
Failure to hold the motor in gear by physical or mechanical means could result in the motor going into neutral with resultant too high RPM and possible explosion of motor parts.
Factory photograph of spring holding shift lever in gear during tank testing
Spring, P/N 304283
As shown in the illustration, the shift lever can be held in gear quite easily with spring tension. The spring being used is a 6 h.p. tilt lever stabilizer spring P/N 304283, available from your parts stock or your parts distributor. We are illustrating the springs use on a 65 h.p. motor; however, it will work equally well on 50 h.p. and all V-4 models.
⚠
SAFETY WARNING
Caution should be taken to stay clear of the flywheel and other moving parts when running an engine with the motor cover off. Be careful of loose clothing or hair which may become entangled in the motor.
EVINRUDE MOTORS
Service Department