← Back to 1970-1980 OMC service bulletins

Evinrude Propeller Bulletin #1008 - Thru-Hub Exhaust Propeller Installation

Issued April 1973, this Evinrude service bulletin explains a revised propeller installation procedure for thru-hub exhaust models. It recommends placing the thrust bushing in the propeller before fitting the assembly onto the shaft and checking for free shaft rotation afterward.

Evinrude Service Bulletin factory header
PROPELLER #1008
April, 1973
NEW PROCEDURE FOR INSTALLING PROPELLERS
ON ALL WITH THRU-HUB EXHAUST MODELS

We have learned of some cases where the positioning of the propeller hub in the propeller makes installation of the propeller on the thrust bushing difficult.

We have found that if you place the thrust bushing in the propeller first, the propeller can be "worked" onto the shaft with little difficulty. If necessary, the propeller nut can be run down on the exposed thread and the propeller can be "wrenched" into position. The propeller shaft should turn freely (engine in neutral) after the propeller is installed. If it doesn't, the propeller is defective and should be replaced following regular warranty procedures.

Factory exploded propeller installation illustration showing thrust bushing, propeller, spacer, propeller nut, and cotter pin
Our tests have indicated that after a short period of operation the propeller and hub will align properly and future removal and installation can be done with no difficulty.
EVINRUDE MOTORS
Service Department

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Propeller Wrench & Marine Spline / Triple-Guard Grease

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.