Back to OMC service bulletins

Evinrude Starter Bulletin #1010 - Starter Lockout Lever Adjustment

April 1973 factory procedure for adjusting the starter lockout lever on 1973 Evinrude 18 and 25 HP outboards. Replaces the service manual procedure and specifies the clearance adjustment and final check after shifting through forward and reverse.

Evinrude Service Bulletin factory header
STARTER #1010
April, 1973
NEW PROCEDURE FOR ADJUSTING STARTER LOCKOUT LEVER
ON 1973 18, 25 H.P. MODELS

The new adjustment procedure described below should be used in place of the procedure described in your 1973 service manual (page 8-4). This new procedure will provide more consistent adjustment of the lockout lever clearance gap and eliminate the possibility of the locking lever engaging when the shift lever is in neutral.

Factory photograph showing starter lockout lever, starter pulley lug, lower lockout lever, and adjusting screw

1. Apply a small amount of OMC Sea-Lube* anti-corrosion lubricant to the lockout lever at its point of contact with the lower lockout lever.

2. Place shift lever in neutral position. Loosen locknut and turn adjusting screw so that the clearance between the lockout lever and lug on starter pulley is 1/8". Now turn adjusting screw so that a final clearance of .030" - .060" (.75-1.5mm) is obtained.

3. Move the shift lever to forward, reverse, and back to neutral. Recheck the lever to lug clearance. Clearance should be less than .090" (2.3mm). If clearance is greater than .090" (2.3mm), readjust following step 2 above. After correct adjustment is obtained, lock the adjusting screw with locknut.

NOTE
It is important that you always start with excess clearance (1/8" or 3.18mm) and adjust down to .030"-.060" (.75-1.5mm). Simply increasing clearance from zero to .030"-.060" (.75-1.5mm) will usually result in an inconsistent final clearance.
EVINRUDE MOTORS
Service Department