
REMOTE CONTROL - ELECTRICAL TROUBLE SHOOTING
ALL MAGNETO CD IGNITION MODELS
50 - 135 H.P.
ALL MAGNETO CD IGNITION MODELS
50 - 135 H.P.
If the key switch or the control box ground circuit are defective, the result may
be one of two things:
be one of two things:
1. You may not be able to turn off the engine with the key switch.
2. You may get a shock when touching the control box.
2. You may get a shock when touching the control box.
If either of these symptoms are reported, check the unit as follows:
NOTE: Disconnect battery before starting tests.
1. Remove throttle & shift control cables from engine to eliminate
possibility of reading a false ground.
possibility of reading a false ground.
2. Using an ohmmeter set to the low ohms scale, check for good
ground between ground terminals of engine and control box. If
ohmmeter shows a high or infinite reading, the cause of excess
resistance must be determined & corrected.
ground between ground terminals of engine and control box. If
ohmmeter shows a high or infinite reading, the cause of excess
resistance must be determined & corrected.
3. Check the ignition switch and wiring to determine if they are
defective. This can be done by first removing the black/yellow
stripe lead from power pack ignition switch terminal (terminal
5 on 50 h.p., 6 on 65 h.p., or 1 on 85-135 h.p.) and then con-
necting ohmmeter between engine ground terminal and loose
end of black/yellow stripe lead. With ignition switch in "off"
position, meter should show low resistance. If reading is high
or infinite, the wiring or switch are defective and must be
repaired or replaced.
defective. This can be done by first removing the black/yellow
stripe lead from power pack ignition switch terminal (terminal
5 on 50 h.p., 6 on 65 h.p., or 1 on 85-135 h.p.) and then con-
necting ohmmeter between engine ground terminal and loose
end of black/yellow stripe lead. With ignition switch in "off"
position, meter should show low resistance. If reading is high
or infinite, the wiring or switch are defective and must be
repaired or replaced.
NOTE: Any electrical connections bared during tests should be recoated with
liquid neoprene (Part No. 315417).
liquid neoprene (Part No. 315417).

EVINRUDE MOTORS
Service Department
Service Department