← Back to 1970-1980 OMC service bulletins

Evinrude Engine Mounting Bulletin #1021 - 1974 Transom Hardware

Issued September 1973, this bulletin explains why owners of 1974 70 H.P. long-shaft and V-4 outboards should retain selected nuts, bolts, and washers from the shipping crate for mounting the engine to the boat.

1973 Evinrude factory letterhead left section1973 Evinrude Service Bulletin letterhead right section
ENGINE MOUNTING #1021
September, 1973
STERN BRACKET TO BOAT TRANSOM HARDWARE
ON 1974 70 (LONG SHAFT) AND V-4 MODELS

In the past, the bolts used to attach the engine to the wooden support member were "throwaway" items. This will be changing. In the near future, the old engine packing hardware will be phased out and two of the four bolts used to secure the stern brackets to the boat transom will be used. There will only be two bolts (formerly four) packaged into the owners kit. When this change goes into effect, the wooden support member in the shipping carton will be prominently stenciled with the following wording:

RETAIN THESE PACKING
NUTS, BOLTS AND WASHERS
TO INSTALL ENGINE ON BOAT
Remember to keep this hardware in a safe place for eventual use when mounting the engine to the boat.
EVINRUDE MOTORS
Service Department