← Back to 1970-1980 OMC service bulletins

Evinrude Fuel System Bulletin #1026 - Carburetor Choke Valve Changes

Issued November 1973, this factory bulletin describes revised choke valve bleed holes on 1974 Evinrude 2, 9.9 and 15 HP outboards, with replacement part numbers for cold-start and hot-start complaints.

Original 1973 Evinrude Service Bulletin letterhead
FUEL SYSTEM #1026
November, 1973
CHANGE IN CARBURETOR CHOKE VALVES
ON 1974 2, 9.9 & 15 HP MODELS

We have made several changes in the choke valves used on 2, 9.9 & 15 H.P.
carburetors. The choke valve on 2 H.P. carburetors formerly had two bleed
holes in it while the latest style choke valve has one hole in it. This change
was made to improve the starting characteristics of a cold engine.

On the 9.9 & 15 H.P. engines, the choke valve originally had no holes in it.
The latest carburetors used on these engines will have one hole in the 9.9 H.P.
choke valve and two holes in the 15 H.P. choke valve. These changes help
prevent flooding or overchoking on hot engines.

If you receive customer complaints of hard starting when cold (2 H.P.) or
hard starting when hot (9.9 & 15 H.P.), you should replace the choke valve
with one of the new style valves. The part numbers of the new style choke valves
are:

320178    2 H.P. choke valve
320267    9.9 H.P. choke valve
320268    15 H.P. choke valve
All three choke valves can be obtained through your parts distributor.
EVINRUDE MOTORS
Service Department