← Back to 1970-1980 OMC service bulletins

Evinrude Powerhead Bulletin #1034 - Water in Lower Cylinder

Issued January 1974 for 1971-1974 50 HP outboards, this factory bulletin explains how excessive exhaust back pressure can allow water into the lower cylinder and describes an exhaust-housing relief-hole modification.

Original Evinrude Service Department letterhead Original Evinrude Service Bulletin banner
POWERHEAD #1034
January, 1974
WATER IN LOWER CYLINDER 1971-1974 50 HP MODELS

▣ NOTE
If a 50 h.p. engine is brought in for service and the condition is diagnosed as water in the lower cylinder, it may have been caused by excessive back pressure in the exhaust system. Excessive back pressure is usually the result of running with the exhaust tube too deep in the water (as in houseboat, barge or other displacement hull applications). To eliminate the back pressure, we have added six additional 1/4" exhaust relief holes to the inner exhaust housing.

If water in the cylinder is not due to leaking cylinder head and exhaust manifold gaskets or pourous cylinders, you should modify the exhaust housing. This can be most easily done by using a 1/4" drill bit and, using the six original 1/4" holes as drill guides, drilling through the exhaust housing. See illustration.

Factory illustration showing drilling exhaust relief holes in the exhaust housing

Models built after the following serial numbers already have the additional exhaust relief holes.

50442 S/N 01100 50443 S/N 01422 50472 S/N 01350 50473 S/N 05136
EVINRUDE MOTORS
Service Department

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Cylinder Hone Tool, Piston Ring Compressor & Digital Bore Caliper

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.