← Back to 1970s OMC service bulletins

Evinrude Engine Mounting Service Bulletin #1036 - Defective Pivot Screw

Issued January 1974, this bulletin identifies a potentially brittle upper pivot screw, part number 122680, on power tilt and trim model 135489. It illustrates the pivot screw locations and how to distinguish suspect screws from acceptable replacements, with removal instructions and warranty claim information.

Evinrude Service Bulletin header
ENGINE MOUNTING #1036
January, 1974
DEFECTIVE PIVOT SCREW P/N 122680 ON MODEL 135489
NOTE
We recently learned that a quantity of upper pivot screws on the power tilt and trim
unit were made from the wrong material. (See Figure 1) When this material is made
into bolts in the usual manner, structural changes may occur in the material which
cause it to become brittle. If this occurs, the bolts may break in the thread area
allowing the tilt and/or trim cylinders to come loose. This in turn may result in damage
to the motor or power trim unit. Since introduction of the engines with power trim four
different screws (in three visually different styles) have been used. See Figure 2.
Figure 1, power tilt and trim unit showing pivot screw positionsFigure 2, comparison chart for pivot screws A through D
Figure 1
Figure 2
If you were shipped engines involved in this program, a listing of those motors is
attached. Please check any of these engines which you have in stock. Also, please
have any customers who have purchased one of these engines from you bring his rig
in. Check the pivot screws by touching a magnet to the head of each one. If the magnet
is attracted to the screw and it has a trademark on its head as shown in Figure 2,
panel "A", it should be replaced. Removal can be most easily accomplished by tilting
the engine to the full up position. In this position all pressure is off the port side screw.
Remove & replace this one first. When removing the starboard screw, lift up on the
gearcase slightly while removing and replacing the screw. Torque new screws to 10-12
foot pounds.
Obtain the replacement screws needed from your Parts Distributor. After installing the
new screws, send the old screws and a warranty claim to the Evinrude Service Dept.
Upon receipt of the screws and claim, a credit voucher for the parts and a $3.50 labor
check per changeover will be issued.
EVINRUDE MOTORS
Service Department

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Power Trim & Tilt Hydraulic Fluid & Spanner Wrench

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 122680

Search for original or compatible replacement part 122680. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.