← Back to 1970-1980 OMC service bulletins

Evinrude Service Bulletin #1041 - 1974 9.9 and 15 H.P. Service Tips

Issued April 1974, this factory bulletin explains rewind starter repairs and how to diagnose engines that jump out of gear, including inspection of the gearcase shifter lever and its welded joints.

Evinrude Service Bulletin factory header
MISCELLANEOUS #1041
April, 1974
SERVICE TIPS 1974 9.9 & 15 H.P. MODELS

In addition to the service information in your service manuals, the following steps should be taken if you have a repair in the rewind starter or if you receive a customer complaint that the engine jumps out of gear.

REWIND STARTER REPAIRS.

  1. If the starter rope breaks, replace it using a 64" piece of 1/8" diameter rope cut from 100 foot roll 316706. (Early production engines were equipped with a 5/32" diameter rope 71-1/2" long.)
  2. If the rewind starter spring breaks, examine the cup & spring guide assembly (P/N 386113) to see if it is identified by a red or blue dye mark or the stamped letter "A". If no dye mark or stamp mark are found, the cup should be replaced.

    When replacing the spring, make sure you do not distort or otherwise damage the outer end of spring during reassembly.

    Replace the starter rope as explained in "1" above.

ENGINE JUMPS OUT OF GEAR.

If your customer indicates that the engine is jumping out of gear, you must first determine if the problem is occurring in the gearcase or is being caused by misadjustment of the shift lever on the powerhead. Mount the engine in a test tank, disconnect the shift lever detent (on powerhead) and run engine in gear. If engine does not jump out of gear, problem is caused by a misadjusted shift lever detent. Readjust following procedure explained on page 6-19 of your service manual.

If engine still jumps out of gear, even though shift lever detent is disconnected, the problem is in the gearcase. Remove the gearcase & check the position of the lower shift rod height as explained on page 6-18 of your service manual. If this adjustment is to specifications, the problem is occurring within the gearcase. Disassemble gearcase and inspect outer diameter of hub of forward gear.

(continued)

If any wear marks are seen, it is an indication that the shifter lever is rubbing. Inspect the shifter lever for welding flash at points indicated. See illustration.

Factory photograph of shifter assembly bent, with arrows identifying welding flash to remove

If any is found, file it off. Check to make sure shifter assembly is not bent or twisted to one side. If it is, straighten or replace it as required. Finally, inspect shifter's freedom of movement at the riveted joint. If this joint is not free, replace the assembly.

EVINRUDE MOTORS
Service Department