Back to 1970-1980 OMC service bulletins

Evinrude Ignition Bulletin #1045 - Ignition Coil Ground Lead Routing

May 1974 service tip for 2, 4 and 6 HP Evinrude outboards. The factory photographs show how to correct an ignition coil ground lead routed over the top of the coil after flywheel removal.

Evinrude factory bulletin header
IGNITION #1045
May, 1974
IGNITION COIL SERVICE TIP FOR 2, 4 & 6 H.P. MODELS
Figure 1: ground lead routed over the ignition coil Figure 2: ground lead bent downward beneath coil top
Figure 1
Figure 2
Whenever the flywheel is removed from a 2, 4 or 6 H.P. engine, the ignition coil ground lead routing should be checked. If you find the ground lead going over the top of the coil as in figure 1, bend it down as shown in figure 2.
EVINRUDE MOTORS
Service Department