Back to 1970s OMC service bulletins

Evinrude Service Bulletin #1050 - Engine Mounting Bolts

Issued June 1974, this safety bulletin identifies the correct engine mounting bolt lengths and factory part numbers for outboards with adjustable transom brackets. It emphasizes full nut thread engagement and warns against substituting bolts of unknown quality.

Evinrude Service Bulletin
ENGINE MOUNTING #1050
June, 1974
SELECTING THE CORRECT ENGINE MOUNTING BOLTS
FOR ALL MODELS WITH ADJUSTABLE TRANSOM BRACKETS
Safety warning symbolSAFETY WARNING:

For proper engine mounting, the nuts used with the engine mounting bolts must have full thread engagement on the bolt.

The stainless steel bolts supplied with the engine are 3-1/2" except for those engines which are factory equipped with power trim in which case 4" bolts are supplied. In the majority of cases, these bolts are more than adequate in length. However, for those installations where the transom is too thick and full nut engagement on the bolt threads cannot be obtained, longer bolts are available.

The part numbers of our various engine mounting bolts are:

These bolts are made with the material and strength required for this particular application; do not substitute bolts of unknown quality.

Part No.Length
3185733-1/2"
3133274"
3187785-1/4"
3136726"
EVINRUDE MOTORS
Service Department

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

3/8" Drive Click Torque Wrench (Inch-Pounds) & Blue Threadlocker

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 3133274

Search for original or compatible replacement part 3133274. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.