POWERHEAD #1054
August, 1974
HARD STARTING 1972-1973 50 HP ROPE START MODELS
To overcome starting difficulties, the following changes are recommended on the above model motors:
Increase neutral speed setting:
The preferred method is to replace the 317597 Cam by the 1974 "start" marked throttle cam P/N 319835 (Fig. 1). Grind Follower Cam Interlock down to enable the center of the throttle cam roller to align with the "start" mark. Make sure pick-up timing is correct (3½° ± 1°).

Figure 1
An alternate method is to remove follower Cam Interlock P/N 317347 and grind head down as illustrated so as to obtain a maximum neutral speed of 3500-4000 RPM (Fig. 2).

Figure 2
We also recommend to install hotter AC-M40FF plugs. These spark plugs have a lower voltage requirement and are more foul-resistant.
In addition to facilitate easier starting, we also suggest replacing the 385752 cover & eyelet assy by P/N 387075 which has a roller to reduce starting effort when pulling the rope upward, rather than straight out (Fig. 3).

Figure 3
EVINRUDE MOTORS
Service Department