Back to 1970s OMC service bulletins

Evinrude Service Bulletin #1057 - Fuel Pump Service Tip

Issued September 1974, this bulletin explains how to test fuel pump performance on 4 through 25 HP Evinrude outboards at 1500 RPM using a temporary clear fuel hose and connector. It includes the four-minute operating test and criteria for replacing the pump.

Evinrude Service emblem
BULLETIN
FUEL SYSTEM #1057
September, 1974
FUEL PUMP SERVICE TIP FOR 4 THRU 25 H. P. MODELS

As far as the fuel pump is concerned, the most demanding engine speed for proper operation is 1500 R.P.M. Thus, a fuel pump which operates well at idle or fast throttle positions may cause trouble if the engine is operated at approximately 1500 R.P.M. An engine experiencing fuel pump difficulties at this speed will tend to die but can be immediately restarted after priming with the primer bulb.

If you receive a customer complaint where the fuel pump is suspected, test the pump using the simplified procedure described below rather than the procedure described in your service manual. Equipment required for this test is a 3 to 4 foot length of fuel line hose (clear plastic 1/4" I.D. fuel hose is preferable so you can see the fuel rise from the tank) and a fuel line connector P/N 376156.

Assemble hose to connector and test as follows:

  1. With engine in test tank, place fuel tank so that fuel level in tank is 24" below the transom height.
  2. Start engine using regular hose and primer bulb assembly. Adjust speed to 1500 R.P.M.
  3. While engine is running, disconnect hose and primer bulb assembly at engine. Connect length of test hose to engine connector and place loose end of hose into tank through filler neck.
  4. If engine continues to run for 4 minutes at 1500 R.P.M., the fuel pump is good. If engine stops, replace pump and repeat test.
EVINRUDE MOTORS
Service Department

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Carburetor Cleaner Spray, Jet Cleaning Wires & Rebuild Kit

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 376156

Search for original or compatible replacement part 376156. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.