Back to 1970s OMC service bulletins

Evinrude Powerhead Bulletin #1058 - Water in Cylinders

December 1974 guidance for water entering cylinders on 1973 and 1974 Evinrude 135 HP outboards. Identifies exhaust manifold screw P/N 317972, access procedures, improved screw material, and a 5-7 ft. lbs. tightening specification.

Evinrude Service Bulletin header
POWERHEAD #1058
December, 1974
WATER IN CYLINDERS OF 1973 AND 1974 135 HP MODELS
▣   NOTE:

The Evinrude Service Department has recently learned of a number of motors with water entering the cylinders from the exhaust manifold. When this problem occurs, make sure you check the long exhaust manifold screw (P/N 317972). If the head has broken off this screw or if it is not torqued properly (resulting in low torque), water can enter the cylinders. Since this screw is located near the center of the exhaust manifold, you must remove the exhaust manifold cover to gain access to the screw.

Factory exploded exhaust manifold illustration identifying screw 317972, cover and exhaust manifold

It is possible to remove the two screws at the bottom of the exhaust manifold cover by using a ¼” drive 3/8” deep socket attached to a ¼” drive universal joint and a ¼” drive speeder wrench. The exhaust manifold cover screws behind the ignition components can be reached by first removing the three screws holding the electrical component bracket to the powerhead and then lifting the bracket to expose the cover screws.

Normally, the exhaust manifold on the 135 H.P. will remain on the powerhead when the exhaust manifold cover is removed. If P/N 317972 screw is broken, both parts will come off together.

We recently changed the material in this screw to improve corrosion resistance and eliminate the problem of head breakage. These improved screws have heads stamped “B-8” and should be installed with a torque of 5-7 ft. lbs. (7-10 N·m). All 1975, 135 H.P. outboards will have the improved screw installed.

EVINRUDE MOTORS
Service Department

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Cylinder Hone Tool, Piston Ring Compressor & Digital Bore Caliper

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 317972

Search for original or compatible replacement part 317972. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.