Back to 1970-1980 OMC service bulletins

Evinrude Powerhead Bulletin #1059 - Flywheel Key Installation

Issued October 1974, this bulletin corrects the flywheel key installation procedure for 1974 and 1975 Evinrude 9.9 and 15 HP engines. The key must sit parallel to the crankshaft taper, rather than the crankshaft centerline as stated in the earlier service manuals.

Evinrude Service Bulletin factory header
POWERHEAD #1059
October, 1974
FLYWHEEL KEY INSTALLATION ON 1974 & 1975 9.9 & 15 HP MODELS
NOTE:
When inserting the flywheel key into the crankshaft keyway on 9.9 & 15 H.P. engines, make sure the single upset mark on the side of key is facing down and the top surface of the key is parallel to the crankshaft taper (see illustration). Correct installation is important since the key also drives the ignition cam and, if there is not enough bearing area on the driving surface, the cam’s keyway will become worn resulting in erratic spark timing.
Factory illustration showing flywheel key installed parallel to the crankshaft taper, with inset key orientation
The 1974 9.9 & 15 H.P. service manuals are incorrect in stating that the key should be installed parallel to the crankshaft centerline (page 4-10 and figure 4-33 on page 4-11). Please note this correction in your manuals.
EVINRUDE MOTORS Service Department

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Universal Flywheel Puller Kit & Valve Lapping Compound

Search for these supplies on Amazon

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.