Back to 1970s OMC bulletins

Evinrude Lower Unit Bulletin #1080 Rev. 1 - 1975 Gearcase Recall

June 1975 revised Evinrude field modification program covering shift rod retaining-ring failure, affected serial numbers, gearcase repair steps and warranty handling for selected 70, 85, 115 and 135 HP outboards.

Evinrude Service Bulletin letterhead
LOWER UNIT #1080 REV.1
June, 1975
GEARCASE FIELD MODIFICATION PROGRAM
FOR 1975 70, 85, 115 AND 135 H.P. MODELS

This service bulletin covers the recall campaign of some 1975 70 through 135 H.P. outboards as described below. If you have purchased any of the outboards involved, you would have been notified by Certified Mail prior to this bulletin.

Some 1975 70 H.P. and all 1975 85, 115 and 135 H.P. motors built before February 10, 1975 are affected.

Dislocation of a retaining ring in the Shift Rod Assembly allows the shifting mechanism to separate and malfunction.

If the mechanism malfunctions, the operator can move his remote control shift lever from reverse, through neutral and into forward gear, but his gearcase will remain in reverse.

The operator may become confused. His boat will be moving backwards when he feels it should be moving forward. In tight quarters, this could be hazardous.

All 1975 model units built after the following serial numbers are NOT AFFECTED:

Model NumberSerial Number
135543E01542
135583E03105
135589E02844
135593E05114
85593E07236
70573B06895
70572B01170
(over)
LOWER UNIT #1080 REV.1

Below is an outline of the procedure to follow to complete modification, identify engine and obtain reimbursement for repair. Follow exact procedure found on “Instruction Sheet for Shift Rod and Plunger Kit” and dealer letter dated March 17, 1975.

Repair Procedure:

  1. Remove gearcase
  2. Disassemble gearcase
  3. Remove shift rod and plunger
  4. Clean all parts
  5. Reassemble gearcase using new shift rod and plunger.
  6. Pressure test gearcase
  7. Refill gearcase
  8. Reinstall gearcase
  9. Mark engine*
  10. Test engine

* Be sure to scribe or stamp a “T” in both areas of all engines that have the shift rod and plunger kits installed. In the future they can be easily identified by anyone servicing the engine as one that has already been modified.

Warranty Procedure:

  1. If outboard was transferred to another dealer notify us immediately.
  2. Engine sold but not registered - notify customer, modify engine and send in registration card.
  3. After installation return special claim to us.
  4. Tag parts and hold for inspection by Evinrude Area Service Manager or District Sales Manager.
EVINRUDE MOTORS
Service Department