← Back to 1970s OMC service bulletins

Evinrude Lower Unit Bulletin #1084 - Clutch Dog Shifter Installation

Issued in May 1975, this bulletin explains how backward installation of clutch dog shifter P/N 319895 can damage the clutch dog and small gearcase on 1975 50 HP and short 75 HP models. The factory photograph identifies the stamped “prop end” marking used for proper orientation.

Evinrude Service Bulletin factory letterhead
LOWER UNIT #1084
May, 1975
CORRECT INSTALLATION OF #319895 CLUTCH DOG SHIFTER FOR
1975 50 H.P. AND SHORT 75 H.P. SMALL GEARCASE MODELS

Recently, we have inspected several of the #319895 clutch dog shifters which have failed on 50 or 75 H.P. small gearcase models. In every case the clutch dog shifter has been installed backwards on the prop shaft. The results are excessive loads being applied to the tangs of the clutch dog.

Factory photograph showing prop end marking on clutch dog shifter
The tangs become rounded or break off often causing severe damage to the gearcase components due to the pieces getting into the bearings or between the teeth of the gears. Since the clutch dog shifter is stamped “prop end” as shown in the illustration, the mechanic should not have any difficulty in making the correct installation.
EVINRUDE MOTORS
Service Department

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Lower Unit Gear Oil Pump & Seal Puller Tool

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 319895

Search for original or compatible replacement part 319895. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.