Back to service bulletin index

Evinrude Service Bulletin #1143: LOWER MOUNTS FOR: 175 and 200 H.P. - All; 140 H.P. - All; 85 and 115 H.P. - 25 Inch Transoms

Factory safety warning explaining the three lower engine mounts, their identification colors and correct applications on high horsepower Evinrude outboards.

Evinrude service bulletin shared header
ENGINE MOUNTING #1143
September, 1976
LOWER MOUNTS FOR: 175 and 200 H.P. - All; 140 H.P. - All; 85 and 115 H.P. - 25 Inch Transoms
⚠ SAFETY WARNING

The above listed Evinrude models are high powered motors designed to give stable boat performance on most boats with appropriate horsepower ratings. The degree of stability will vary with different boat-propeller-motor combinations. If a boat has a tendency to be unstable (“fishtail”) at high speed or in turns, it may require optional motor mounts and/or twin cable steering. The necessary mounts and/or steering kits to correct this condition, if it exists for a particular combination of boat-propeller-motor, are available thru your OMC Parts and Accessories distributor.

Twin cable steering must be used for the above listed motors in dual installations.

There are three lower mounts used in the above listed model motors which are alike in appearance and are installed in the same manner.

Improper application of these mounts could seriously affect the performance of the motor and possibly cause instability of the boat.

Mount #387783 is designed for normal applications of the 85 and 115 h.p. 25 inch transom models, and the 140 h.p. in both the 20 and 25” transom models. This mount can be identified by its red color and the part number appears in raised numbers.

Mount #387243 is designed for use with both the 175 and 200 h.p. V-6 models in normal applications. This mount can be identified by its blue rubber color and has the part number in raised numbers on it also.

Mount #387998 is the high performance mount and should be used on any of the above motors if the boat has a tendency to be unstable (“fishtail”) at high speed or in turns and the installation of twin cable steering has not eliminated the unstable tendency. This mount can be identified by its green color and the part number in raised numbers.

Under no circumstances are lower mounts to be installed other than in matched pairs.

No substitution of mounts should be made from those called for in the parts catalog, except as described above.

EVINRUDE MOTORS
Service Department

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Propeller Hub Kit & Prop Nut Wrench

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 387783

Search for original or compatible replacement part 387783. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.