Back to service bulletin index

Evinrude Service Bulletin #1150: FREEZE DAMAGE TO WATER PUMPS AND GEARCASES

Factory precautions for inspecting Evinrude outboard water pumps and gearcases following freezing temperatures.

Evinrude service bulletin shared header
LOWER UNIT AND PROPELLER #1150
May, 1977
FREEZE DAMAGE TO WATER PUMPS AND GEARCASES

Because of the extremely cold weather experienced in many parts of the country, it is possible that many motors have been exposed to sub-freezing temperatures without being properly winterized. In some areas, motors have actually been frozen into ice on lakes which normally did not freeze during the winter.

Extreme care must be exercised when returning these motors to service, as damage may have been done to the water pumps and gearcases.

Before attempting to start a motor that has been frozen, it is recommended that you remove the gearcase from the motor. Inspect the water pump components for damage. If any attempt was made to start the motor while frozen, it is possible that the impeller blades were frozen in the water pump housing with resultant impeller damage.

Drain the oil from the lower unit. Inspect the unit for external damage and pressure test to determine if there was any damage to seals or O-rings. Refill lower unit with the proper OMC Lubricant.

Reassemble lower unit components and reinstall on motor. Normal pre-season service and maintenance should then be performed on the motor.

Note: Freeze damage to a motor or resultant failures caused by freeze damaged components will not be covered by Warranty.

EVINRUDE MOTORS
Service Department