← Back to 1970-1980 OMC service bulletins

Evinrude Lower Unit Bulletin #1183 - Removal of Driveshaft in V-4 & V-6 Gearcase

Issued in April 1978, this factory bulletin explains why some V-4 and V-6 outboard driveshafts are difficult to remove from the gearcase. Evinrude clarified that a loose or tight taper fit does not materially affect gearcase service life and announced a redesigned driveshaft removal tool, part number 389929.

Evinrude Service Bulletin factory letterhead
LOWER UNIT #1183
April, 1978
SUBJECT:   REMOVAL OF DRIVESHAFT IN V-4 & V-6 GEARCASE

Some driveshafts in V-4 and V-6 outboards may prove very difficult to remove while others can be lifted out with very little effort.

Even though the taper on the driveshaft is not intended to be a locking taper or to provide an interference fit, the tolerances are quite close and may produce the tightness sometimes encountered. This condition can be considered normal and in either event, loose fit or tight fit, does not materially affect the service life of the gearcase.

A redesigned Driveshaft Remover Special Tool P/N 389929 will soon be available from your distributor for removal of the tight fitting driveshafts.

EVINRUDE MOTORS
Service Department

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Lower Unit Gear Oil Pump & Seal Puller Tool

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 389929

Search for original or compatible replacement part 389929. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.