Back to OMC bulletin index

Evinrude Powerhead Bulletin 1199 Revised - Piston Skirt Clearance

October 1978 revised factory clearance chart for 1977-1978 Evinrude outboards from 2 to 235 HP.

Evinrude Service Bulletin letterhead
POWERHEAD #1199 (Revised)
October, 1978

SUBJECT:   CYLINDER TO PISTON SKIRT CLEARANCE

MODELS:   2 H.P. - 235 H.P. 1977 THRU 1978

Most engine models have had adjustments made in the specification of piston skirt to cylinder bore clearance which may not have appeared in your Service Manuals.

This information is shown in Clearance Chart of Section 2 - General Service Information - in the various Service Manuals.

The following chart incorporates all current cylinder to piston clearances. Change the specifications in your 1977 - 1978 Service Manuals as shown in this chart.

ENGINE MODELCYLINDER TO PISTON
SKIRT CLEARANCE
2 HP.0055 Max - .0043 Min
(.140 - .109 mm)
4 HP.0030 Max - .0018 Min
(.076 - .046 mm)
6 HP.0030 Max - .0018 Min
(.076 - .046 mm)
9.9 & 15 HP.0038 Max - .0025 Min
(.097 - .064 mm)
25 & 35 HP.0065 Max - .0035 Min
(.165 - .089 mm)
55 HP.0095 Max - .0055 Min
(.241 - .140 mm)
70 & 75 HP.0065 Max - .0045 Min
(.165 - .114 mm)
85 HP.0065 Max - .0035 Min
(.165 - .089 mm)
115 & 140 HP.0085 Max - .0055 Min
(.216 - .140 mm)
150 - 175 - 200 - 235 HP.0085 Max - .0055 Min
(.216 - .140 mm)
EVINRUDE MOTORS
Service Department
CR 78-44   REV. 1