SB-1252 - Overheating of Propeller Hubs

Issued January 1971, this Johnson bulletin expands cooling-water trim-tab guidance for 55, 60, 85 and 115 H.P. outboards, including gearcase drilling exceptions and serial-number changes.

Johnson Motors Service Bulletin factory letterhead
SB-#1252

January, 1971

SUBJECT:  OVERHEATING OF PROPELLER HUBS

MODELS:  55, 60, 85, and 115 H.P.

We recently released a new trim tab for the subject models.  This trim tab (P/N 316981) has a water pick-up hole which provided additional cooling of the propeller hub on slow moving boats such as house boats.  We recommend that you install this new trim tab on any 55, 60, 85, or 115 H.P. engine used on slow moving boats.

NOTE:  60ES71 engines built after Serial #3483142, 60ESL71 engines built after Serial #3486873, 85ESL70 engines built after Serial #3335537, and 115ESL70 engines built after Serial #3344891 already have the new trim tab.)

All 55 gearcases require drilling to open passage up to 3/16" diameter.  All 60 gearcases require drilling except those with the cast letters N, R, or T on the port side of the gearcase just above the anti-cavitation plate.

When the gearcases are removed from any of these engines, the rubber seal between the inner exhaust tube and the gearcase should be replaced.

All 85 and 115 gearcases require drilling except those with the cast letter "F" on the port side of the gearcase just above the anti-cavitation plate, or the letter "L" stamped above the trim tab of the gearcase.  (See SB-#1243).  Use a 3/16" diameter long series (5-3/4") bit to drill the water passage.

JOHNSON MOTORS

Doug Cankar
Technical Data Coordinator
DC:sl
NOTE:Post on your 55, 60, 85, and 115 H.P. indexes under the heading "Lower Unit".

Historical notes

Johnson trim tab P/N 316981 provided an additional cooling-water pickup for the propeller hub. This bulletin expands the earlier instructions in SB-1243 - Overheating of Propeller Hubs to include 55 and 60 H.P. models.

1970-1980 Johnson Service Bulletin Index