Back to previous page

SB-1337 - Snap Ring Program

Issued February 1974, this Johnson Service Bulletin warns of potentially defective shift assemblies on certain 1973 Johnson 50 through 135 H.P. outboards. The original one-page factory bulletin is reproduced below as searchable text.

Johnson Outboards Service Bulletin factory letterhead
SB-#1337

February, 1974

SUBJECT: Snap Ring Program

ON MODELS: 1973, 50 thru 135 H.P.
Shift Rod, Plunger and Snap Ring 50 and 65 H.P.
P/N 386592; 85, 115 and 135 H.P. P/N 386593

SAFETY WARNING

In September of 1973 we notified all Johnson dealers who had been shipped 50 thru 135 H.P. outboards which were within the serial number group that could have a defective shift rod, plunger and snap ring assembly. Customers who had registered outboards in this group were also notified to make arrangements to have you perform a shift test on their outboard. With your notification you also received all necessary forms and instructions to complete the test and notify us when the test was performed.

The snap ring may become dislodged during shifting from reverse to neutral or forward. This results in the shifter dog remaining in reverse, while the position of the shift/throttle control lever could indicate neutral or forward gear. Due to the safety hazard this failure could produce, it is of vital importance for you, the Johnson dealer, as well as Johnson Outboards, that this test be performed and shift assemblies installed when necessary on all outboards within this serial number group whether they are in your stock or sold to customers.

We are very concerned since our records indicate that less than 30% of the engines in this serial number group have been tested and filed with us. We have complied with the federal regulations by notifying you and the customers of record so please take the initiative and make the shift test and notify us after completion. Your immediate attention to the completion of this program will assure your customers of the safest most pleasurable boating possible.

If you have any questions concerning this program, call Mr. Frank Normoyle of Johnson Outboards, Service Department at (312) 689-6260.

JOHNSON OUTBOARDS

D. J. Leinonen

Technical Data Coordinator

NOTE: Post on your 50 thru 135 H.P. indexes under the heading "Lower Unit".

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

12-Inch Stainless Steel Machinist Ruler / Shift Rod Height Gauge

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 386592

Search for original or compatible replacement part 386592. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.