Back to previous page

SB-1360 - Attaching Remote Control Cables to Engine

Issued October 1974, this Johnson Service Bulletin distinguishes cable rigging for 1975 70 H.P. B-suffix engines from E-suffix 70 H.P. and 75 H.P. engines. It refers to revised instructions printed on the reverse, which is absent from the available scan.

Original Johnson Service Bulletin letterhead
SB-#1360
October, 1974
SUBJECT: Attaching Remote Control Cables to Engine
ON MODELS: 1975 70 & 75 H.P.
Instruction sheet 320314, packaged with each remote control, gives a procedure for attaching the throttle and shift cables to 50 through 135 H.P. engines. The procedure for 70 H.P. engines beginning on page 5 of this sheet should only be used on 70 H.P. engines which have the letter "B" as a model suffix (as in 70ES75B). Engines which have the letter "E" as a model suffix (as in 70ES75E) should be rigged following the procedure given for 75 H.P. engines.
To simplify cable installation on 70 H.P. "E" models and 75 H.P. models, we are changing the recommended procedure as shown on the reverse of this bulletin.
JOHNSON OUTBOARDS

D. J. Leinonen
Technical Data Coordinator
NOTE: Post on your 70 and 75 H.P. Index under heading,
"Miscellaneous" and on your Miscellaneous index under
heading "Service Procedure Change".

DJL/kr

Archive completeness: The factory bulletin refers to revised instructions on the reverse side. The supplied PDF contains only this front page, so the reverse-side procedure is not reproduced here.

Related: SB-1302 - New Steering System Recommendations (steering installation information).