Back to previous page

SB-1417 - Replacement of Gearcases

Issued April 1976, this Johnson Service Bulletin explains the differences between early three-screw and later four-screw impeller housings on 1976 35 H.P. outboards, and specifies impeller housing kit P/N 388456 when replacing an early gearcase.

Johnson Outboards Service Bulletin factory letterhead
SB-#1417

April, 1976

SUBJECT: Replacement of Gearcases

ON MODELS: 1976 35 H.P.

The first series 1976 35 H.P. engines ("S" model suffix) had an impeller housing which was attached with three screws. The current series 1976 35 H.P. engines ("G" model suffix) have an impeller housing which is attached by four screws. If you have to replace a gearcase and bearing assembly or a gearcase complete on a first series engine, you will be supplied with a gearcase drilled to mount a four screw impeller housing.

If this first series engine has not already been modified to use a four screw impeller housing, a new impeller housing kit (P/N 388456) should be ordered and installed on the new gearcase. The 388456 Impeller Housing Kit includes instructions which should be reviewed and followed to insure that your customer has the benefit of the latest cooling system improvements.

JOHNSON OUTBOARDS
D. J. Leinonen
Technical Data Coordinator
DJL/kr
NOTE: Post on your 35 H.P. index under heading "Lower Unit".

Tools, supplies and related parts

Suggested products related to this service bulletin. Verify fit and suitability before ordering.

Amazon: tools and supplies

Marine Water Pump Impeller Kit & Infrared Thermometer Gun

Search for these supplies on Amazon

eBay: OMC / Evinrude OEM part 388456

Search for original or compatible replacement part 388456. Check the bulletin for supersessions and model fit.

Click here to search on eBay

Affiliate disclosure: EverythingOutboards may earn a commission from qualifying purchases. As an Amazon Associate, we earn from qualifying purchases.